(949) 429-1089
FLO LOC Products International

Seismic Controller Models

Standard Features:

System Hub: The FLOLOC Seismic Controller Panel is the Hub for the complete system. This is where all control and status wiring for the equipment and SCADA* inputs to and exits from to operate and provide information on the FLOLOC Seismic System:

  • FLOLOC field wiring terminals - all the FLOPAK Actuators and the POWERPAK in a FLOLOC system connect to the Seismic System Hub (Seismic Controller)

  • SCADA terminals - all input and output wiring for the complete seismic system connect to the System Hub (Seismic Controller). The remote functions for SCADA operation of the FLOPAK valve actuator, POWERPAK status and controller features are accessed through this single location.


Standard FLOLOC Interface:

FLOLOC 24 VDC Power
FLOPAK Open/Close Commands
Valve Open/Closed Status
Valve Transition Status
Key Switch Status (Actuator local/remote position status)


Standard SCADA Interface:

SCADA 24 VDC Power
Remote Seismic Sensor Arm / Trip
Remote Seismic Sensor Arm/Trip Status
Remote Valve Position Open/Closed Status
Remote Valve In Transition Status
Remote Key Switch Status (Actuator local/remote position status)


Operator interface panel – provides arm/open and trip/close push buttons, sensor status and valve position LEDs for panel operation

NEMA 4X Fiberglass Enclosure

Optional Features:

Independent control of multiple valves either at the operator panel or via SCADA . (FL201-1X)
SCADA and/or local LED indications for "AC ON", "Fuse Ok", "Battery Ok" and "Battery Low"
Service alarm
Stainless Steel Enclosures
Combination of Seismic Controller and Power Supply in one enclosure

* S.C.A.D.A. (SCADA) - Supervisory Control and Data Acquisition